Currently only for Homematic and Homematic IP roller shutters
Immediately after teaching in shutters or blinds, you can define the end position settings or travel times of your shutters and blinds directly in IQONTROL NEO.
If you want to change the travel times and end position settings again at a later point in time, you can also change them later via the device settings (Rooms → Edit room → Select device).
The travel time is specified here in milliseconds for up and down (and, in the case of blinds, also for slats). The roller shutter is automatically adjusted to match via * Start calibration *.
Here you have to enter the travel time for * up * and * down * in seconds and separate both values with a comma. Automatic calibration is not possible here.